Laser engraving is the small, hand-cutting tool that allows you to do precision cutting or engraving using a laser. This engraver laser costs less than store-bought laser, but they work just as well. Making the laser engraver in a few hours. You must be metal, plastic or wood cut with the laser engraver. Here are some simple steps for you.
For the first step, you must insert the LED module in accordance with the instructions of a module. The differentcharacteristics of the various modules are usually mounted. You should certainly read the instructions carefully.
For the next step in the round hole at the end of the case of plastic that is large enough to fit the form, and then the hole in the roof of a case for the switch. You need a circular opening beyond a plastic case for the power supply.
Then you can open the case and replace the module and the power switchthe correct holes. Paste the form, and passing through the fence to keep them in place. The module is equipped with the red and black wire connected. Red is positive and black is the ground wire. You need the wires from the module to be attached to the switch.
For the next step, you can power a limited space in the section between the opening of a rope and the on / off switch. After that connects to a limitergo through the wire. You also need to connect the wires of a section of the output module, and then the wires of a limiter input section.
It 'also important for you to slide the string through the hole on the right. Then run the wires from the power cord to the limiter.
Glue around the cable to hold it in place. You also have to paste the limiter position. For the final step, close the window and then connect it to thehot glue. This protects the inner workings of the laser.
Friends Link : Precios De Transferencia Best Price Super Store
No comments:
Post a Comment